Add dedicated functions create_dhcpdiscover(), create_dhcpack() and
create_proxydhcpack() for use by external code such as the PXE preboot
code.
Register ProxyDHCP options under the global scope "proxydhcp".
Unregister previously-acquired DHCP and ProxyDHCP settings when DHCP
succeeds.
Add a configuration settings block for each net device. This will
provide the parent scope for settings applicable only to that network
device (e.g. non-volatile options stored on the NIC, options obtained via
DHCP, etc.).
Expose the MAC address as a setting.
RFC 4390 provides for the DHCP client identifier to contain the link-layer
hardware type and MAC address when the MAC address exceeds 16 bytes.
However, the hardware type field is only 8 bits; we were assuming 16 bits.
Arbel and Hermon cards both have multiple ports. Add the
infrastructure required to register each port as a separate IB
device. Don't yet register more than one port, since registration
will currently fail unless a valid link is detected.
Use ib_*_{set,get}_{drv,owner}data wrappers to access driver- and
owner-private data on Infiniband structures.
Pull out common code for handling management datagrams from arbel.c
and hermon.c into infiniband.c.
Add port number to struct ib_device.
Add open(), close() and mad() methods to struct ib_device_operations.
Allow port numbers in iSCSI redirection.
Wait for SCSI status, not just the final data-in (which may be followed
by an explicit SCSI Response PDU if the S bit is not set).
We didn't specify values for MaxRecvDataSegmentLength and
MaxBurstLength (to save space, since we were happy with the
RFC-defined default values of 8kB and 256kB respectively). However,
the OpenSolaris target (incorrectly) assumes default values of zero
for these parameters.
The upshot was that the OpenSolaris target would get stuck in an
endless loop trying to send us the first 512-byte sector, zero bytes
at a time, and would eventually run out of memory and core-dump.
Fixed by explicitly specifying the default values for these two
parameters.
tracking down a bug that turned out to be a free_iob() used where I
needed a netdev_tx_complete(). This left the freed I/O buffer on the
net device's TX list, with bad, bad consequences later.
Also fixed the bug in question.
Michael Brown
Marty Connor
Alexey Zaytsev