oxmc
60ed00046c
- mkbootimg.mk: boot.img uses the normal ramdisk again; the recovery.img rule is guarded so it only builds when recovery is enabled (PAWLET_BUILD_RECOVERY=1) and carries the recovery ramdisk. - config.txt [tryboot] back to boot_partition=2 (A/B trial); recovery enters via reboot,3. - vendor.prop reboot reason back to reboot,tryboot. - drop the no-op reserved-size lines (AOSP ignores RESERVED_SIZE for fixed non-dynamic partitions).
63 lines
1.2 KiB
Plaintext
63 lines
1.2 KiB
Plaintext
# Kernel
|
|
arm_64bit=1
|
|
kernel=Image
|
|
|
|
# Ramdisk
|
|
initramfs ramdisk.img followkernel
|
|
|
|
# Audio
|
|
dtparam=audio=on
|
|
|
|
# Camera
|
|
camera_auto_detect=1
|
|
start_x=1
|
|
|
|
# CPU
|
|
arm_boost=1
|
|
|
|
# Display
|
|
disable_overscan=1
|
|
|
|
# Display panel
|
|
#dtoverlay=vc4-kms-dsi-7inch
|
|
#dtoverlay=vc4-kms-dsi-ili79600-10-1inch
|
|
#dtoverlay=vc4-kms-dsi-ili9881-5inch
|
|
#dtoverlay=vc4-kms-dsi-ili9881-7inch
|
|
|
|
# Graphics acceleration
|
|
disable_fw_kms_setup=1
|
|
dtoverlay=vc4-kms-v3d
|
|
|
|
# I2C
|
|
#dtparam=i2c_arm=on
|
|
|
|
# I2S
|
|
#dtparam=i2s=on
|
|
|
|
# Serial console
|
|
enable_uart=1
|
|
|
|
# SPI
|
|
#dtparam=spi=on
|
|
|
|
# USB
|
|
dtoverlay=dwc2,dr_mode=peripheral
|
|
|
|
[cm4]
|
|
# USB
|
|
dtoverlay=dwc2,dr_mode=otg
|
|
|
|
[all]
|
|
|
|
# A/B boot slot selection via RPi tryboot.
|
|
# Slot A = partition 1 (boot_a) — normal boot, no override needed.
|
|
# Slot B = partition 2 (boot_b) — booted once via `reboot tryboot` (the updater)
|
|
# to trial an update; the firmware reverts to slot A if the trial fails
|
|
# to confirm, so a bad update can't wedge the device. On success the app
|
|
# copies boot_b -> boot_a (via /dev/block/by-name/misc) to make it
|
|
# permanent.
|
|
# Recovery is a separate image on partition 3, entered via `reboot,3`
|
|
# (pawlet-recoveryboot.sh) — not tryboot.
|
|
[tryboot]
|
|
boot_partition=2
|